Monorail monorail car known as the car and driving to break up the implementation of the two chain, chain drive traffic to bracelets, hand in hand to push the implementation of heavy lifting car driver hand car prices, can freely walk in the bottom flange I-beam rails On hand car and wheel flange spacing can be adjusted according to the requirements of the I-beam track width, the manual hoist hanging in the road below, can be composed of manual lifting and transport cart. Purpose: TROLLEYS drive to bracelets, hand car quality walking on the beam at the lower edge of the track, may form a bridge supported by chain hoists, single girder, or jib crane. Tonnage mainly: 0.5T, 1T, 2T, 3T, 5T, 10T, 20T, 30T, 50T. Wholesale hand car, you should make rings when the monorail car Installation 1. Driving is mounted to the left, adjust the quantity equal to the inside right wall washers. But in order to ensure that the gap between the side of the track and the rim, allowing adjustment rings on both sides of the washer when a difference in the number required. 2. Installation morning after driving on the track, tightening the shaft nut hanging, hanging light load test run, to be connected to the roller and the track, then tighten the outer nut, special attention should be locked to each other nuts. 3. Hand monorail car roll gap must be adjusted after mounting sleeve and bottom of the track so that it reaches a predetermined value. Adjustment: Loosen the nut first, moving roller sleeve shaft so that the gap reaches a predetermined value and then tighten the nut. Hand car prices, Shanxi hand car, lifting the Qingyuan Xinyu Xinyu Lifting Limited. Qingyuan Xinyu Crane Limited (xyqz0312.1688.com) strong, credible, in Baoding engineering, construction crane industry has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead Xinyu lifting into the brilliant and you work for a better future!